Rotor Mills for MIG

Rotor Mills for MIG This product technology has been widely valued by the industry. The grinding mechanism of Rotor Mills for MIG is mainly used to determine its wide range of applications, high fine, typical materials: super hard diamond, silicon carbide, metal powder, high purity requirements: ceramic pigment, medicine, biochemistry, medicine. Rotor Mills for MIG converts the normal gas from the gas source portion to nitrogen, carbon dioxide and other inert gas, is an inert gas protection device for use in flammable and explosive and oxidative materials.

Rotor Mills for MIG is used in the powder industry. Rotor Mills for MIG is a supersonic gas stream to form an ultrasonic air flow by a nozzle after refrigeration, filtration, drying, and injects the pulverizing chamber. Accelerated materials gather in the intersection of multiple nozzles jet gas flow, resulting in severe collision, friction and shearing, thereby achieving ultrafine pulverization of particles. Air flow grinding has the characteristics of low energy consumption, stable operation, simple structure, convenient operation and maintenance. It is real multi-purpose, high efficiency, low-cost new crushing equipment. It can be said that modern industrial production is inseparable from airborne flow, but air flow milling equipment often requires continuous operation, long working hours, which is greater than the equipment itself is large.

Technical parameters:
Finished particle size: D50 less than 5μm
Production capacity: greater than 50kg / h

1, pulverizer When homework, the operator should stand in the tangent direction of the hammer rotation, and if you don't wear your gloves, your hand must exceed the security line, not allowing iron and sticks instead of hand feed.
2, pulverizer and power unit should be installed firmly. If the equipment is fixed for a long time, it should be fixed on the cement; if the device is a mobile operation, the unit should be installed on the base made of angle iron, and ensure that the belt wheel groove of the power machine (diesel or electric motor) and the equipment is in the same Rotary plane.
At the same time, check if the leather belt looseness is appropriate.
4 Power machine and pulverizing machine lubricationNo good.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking bullies, do not have a long time overload. If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.