Cell Grinder for Wettable Powder

It is well known that the product technology of Cell Grinder for Wettable Powder has been widely valued by the industry.

Cell Grinder for Wettable Powder temperature is also a factor affecting work efficiency. When the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy. When the titanium powder is pulverized by superheated steam, the vapor pressure is usually from 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after the pulverized surface is low.

AlPa Steel slag Cell Grinder for Wettable Powder case share: This customer is Xi'an Steel Residue Application Technology Co., Ltd., mainly engaged in the reuse of steel slag. During the production process, steel slag ultrafine powder is required, screening the required steel slag micropowder, the customer investigates many domestic powder equipment manufacturers, and finally chose our ALPA Vertical Air Classifier.
Case parameters:
Product particle size: D97: 5-75μm
Hour Yield: 200-500KG

Cell Grinder for Wettable Powder is widely used, do you know how to use it correctly? The following content hopes to help you.
1. Preparation before departure. Check if the host, connector, pipeline, and the valve are normal, working properly.
2, open the machine

(1) Open the compressor power supply, the dust collector pressure valve and the main air valve, open the air pulverizer power switch, and turn on the power switch.

(2) From zero, gradually adjust to the specified speed.

(3) Open the fan, cyclone separator, dust collector, charge motor, open the total power box, set the inverter frequency, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.
3, the sequence of stops:

inverter-feeder-main air valve-compressor-grade impeller-motor cyclone material, dust removal switch-fan-main power supply-air compressor .
4, Maintenance

(1) The motor should be lubricated regularly, but the lubricating oil should not excessively avoid the bearing temperature.
(2) InspectionThe wear of the blade wheel, the helical conveyor and the crushing nozzle is very important.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag, it should be cleaned or replaced.
5. Precautions

(1) When the discharge equipment is run, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric chance are damaged.
(3) Regularly check the safety valve to ensure safety.

Shan dong alpa specializes in the production and development and service of Cell Grinder for Wettable Power Product technology, welcome to consult.With a perfect quality, excellent service, the most affordable price, the company provides the best crusher products and services for customers.