Cell Grinder for baking soda

Publish: 2021-12-07 10:15:26

Views:

We all know that Cell Grinder for Baking Soda is a very strong airflow, many stubborn and hard materials that encounter a crusher will be cut into a uniform block of pieces,

Cell Grinder FOR BAKING SODA should be installed in a place where the site is smooth.

Before working, it is necessary to pick up the processing material, no metal, stone, etc., the hard substances are mixed into the machine, so as not to damage the parts or failures in the machine. Check that each component is firm and reliable before booting. Everything is normal, the side can turn on the power, idle for 1-2 minutes, check whether the operation is normal, everything is normal, it can be pushed.
When operating, the operator cannot leave. Once the sound is abnormal, the power should be disconnected immediately.

When machining raw new friends Chinese medicine crusher, the discharge opening should be tied to the bag. When the pulverizer is in use, if you encounter the power supply voltage, do not use it, so as not to damage the motor. When the power supply voltage is normal, the machine is not easily damaged, and the production efficiency is high.

ALPA Paint Slazing Cell Grinder for Baking Soda Case Sharing: This customer is an investigation of similar domestic companies, and did not find a pulverizer that can smash the paint slag. Finally, I know that our Shandong Alpa is a non-standard custom-made enterprise that is a super-smashing equipment, and I have found us. We have repeatedly tried, and we found a super-pulverizing machine suitable for crushing paint slabs. Finally, the customer purchased our company's Cell Grinder for Baking Soda, the most crushed oil paint slag.

Technical parameters:
finished particle size: D90: 800 mesh
Production capacity: 800-1000kg

1, during production It is necessary to check the temperature rise of the bearing frequently, when the temperature rise exceeds 50 ° C, should be closed, and the reason is to rule out the fault.

2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3, if the loss case should be checked frequently, replace the quality and production volume in time.
4, the blade, the bushing should often check the wear situation. If the wear is worn, the productivity is lowered, and the particle size is replaced after the particle size is replaced.
5, the host and the graded flow bearing are lipids, and the No. 2 special lipids are used 265-295.
6, the replacement period of the bearing is 2000 hours, and the filling of the grease is 1/2 (episode) or 3/4 (down test) of the space in the bearing cavity.It will cause too high of the bearing temperature.
7. The spiral feeder has been changed during the change of the lipid of 4,000 hours, and the calcium-based grease is added.

Welcome everyone to continue to pay attention to our website to learn more!

Previous: Hammer Mills of Lanthanum Aluminum

Next: Rotor Grinder of Coke