Cell Grinder for Hydrocarbon Resin

We all know that Cell Grinder for Hydrocarbon Resin is a strong airflow crushing equipment. Many stubborn hard materials have been cut into a uniform blockbuster,

Cell Grinder For hydrocarbon resin is based on the size of the particle size, the specific gravity is different, and the segmentation speed is different from the principle of the settlement speed in the gas. The classifier, cyclone separator, dust collector, and the introducer make a set of hierarchical systems. Under the action of fan pulleys, the material is moved at a high speed, and the up airflow into the grading area. Under the action of the powerful centrifugal force generated by the high-speed rotation grading turbine, the coarse, fine particles are separated, and the fine particles that meet the particle size requirements by the gap of the grading wheel blades or the dust collector are collected. After the crude particles are partially fine particles, the velocity along the wall to the secondary air is disappeared and reduced.

The strong washing effect of the secondary wind, the thick particles are separated, and the fine particles rise to the secondary level of the secondary level, and the crude particles reduce the discharge port.

Technical parameters:
Finished granularity: 98% over 325 mesh
Production capacity: 2T

before power on, The connection site, sealing and line, etc. are detailed, and everything can be checked if there is no problem before running the powder classifier.
The boot should be operated in the boot order. 3 minutes before shutdown should be stopped, then shut down, the order is opposite to the boot order.
The amount of feed should be determined according to the size of the powder grading machine load, ensuring that the host is in the state of rated load. The particle fineness can be adjusted to adapt to the grading requirements.
Debutors such as the heat-sensitive material, then the power of the main motor is slightly lower than the rated power. The size of the air volume in the delivery line can be achieved by adjusting the damper of the fan.