Hammer Grinder of Stainless Steel Powder

With the development of the times, the progress of society, the development of the market is elegant, and more and more manufacturing have to accelerate innovation, some transformations, some continue to improve the technical level of the product, to adapt to the development of the market, Meet the customer's picky requirements. In the case of continuous changes in the market, only constantly innovation, constantly improving their own technical level, constantly improving their own products, in order to make Hammer Grinder of Stainless Steel Powder industries have a broader development space.

Hammer Grinder of Stainless Steel Powder has a wide range of pulverized granularities, simple and convenient, but during the pulverization process, the crushing effect is often different.

The crushing effect is mainly affected by the following factors:

The temperature and pressure of the gas ratio, the feed particle size, the working fluid, and the pulverization aid. The gas-solid ratio of the pulverizer in crush is an important technical parameter and an important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. But if the gas is too high, not only will waste energy, but will even degrade the dispersion performance of certain pigments.

When pulverizing hard materials, there is a stricter requirement for the particle size of the feed. In terms of titanium powder, it is necessary to control 100 to 200 mesh when pulverizing calcination; the material after pulverizing surface is generally 40 to 70 mesh, and cannot exceed 2 to 5 mesh.
So, should you choose how high pressure when crushing? Those skilled, this is mainly dependent on the comminutability and fineness requirements of the material.

Technical parameters:
Finished particle size: D50: 5-8μm
Production capacity: 450kg

During the production process, the temperature rise of the bearing must be checked frequently, when the temperature rise exceeds At 50 ° C, the check should be stopped, and the reason is to troubleshoot. When the new machine is running, the drive belt is easy to elongate, pay attention to adjust the proper looseness of the belt to ensure the work life of the belt. If the lifting piece should be checked frequently, replace the production quality and production in time. The blade, the bushing should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is roughly discovered to be replaced. Host and grading flow bearingFor grease lubrication, use 2 special lipids, the replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the inner space in the bearing cavity, and it is not too much to fill the grease. Otherwise, the bearing temperature is too high..The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease.In the output shaft E, ie the pulley E, avoiding the weight of the weight, damage the part.It is strictly forbidden to turn the handle on the stop.The lubricating oil used in this regulator is used with N32 alkaline high-zinc high-grade anti-motor oil pressure oil, and the deceleration machine is 401 generally lubricating oil, and it is not necessary to use other machines.After four or five months, new oil should be replaced.

Shandong Shan Dong Alpa produces various types of crushers, can have a variety of materials such as medicinal materials, ingredients, chemicals, etc., the highest effect can be more than 10,000.Our products are non-standardized products, which will customize their products according to your needs, and make a reasonable offer according to the product.