Hammer Mill for chondroitin

Hammer Mill for Chondroitin is a very convenient device that can be used to crush all kinds of products, especially some fine particle products need to be used.

Many manufacturers who want to make a crushing process I will choose to buy a Hammer Mill for chondroitin, but not all crushers can apply to production and processing, and the wrong processing method will make the pulverizer wear speed. The wear of the pulverizer is too fast, and the inner cavity of the pulverizer of the comparison should be used when the material hardness is too large.

The device operates for a long time in a higher pulverized pressure, which requires uniformity of cyclical replacement loss.

The products after the crushing are generally single peaks. If there is a double-peak or peak main reason, the pulverization pressure is unstable. The solution is based on the gas supply of gas source equipment to meet the amount of gas required for work, ensuring that the lowest air supply pressure of the gas is high than the working pressure.
The feed speed is unstable. Solution to check if there is a blockage at the feed valve; the material is not very viscous, uniform in liquidity, and the stable control feed speed. The filter cake is formed in the pulverizer chamber. The solution is suspended, and the filter cake in the pulverizer chamber will then restore production.

Technical parameters:
Finished particle size: D50: 10-30μm
Production capacity: 30-50kg