Hammer Mill of Positive electrode recovery plate

Most of the product production and processing in the current stage uses Hammer Mill of Positive Electrode Recovery Plate for the product, is a very common way of processing, with the continuous improvement of scientific productivity, grading equipment The technology is also imminent. The performance and internal configuration of the grading equipment of the airflow must also keep the trend of the era to continue the upgrade of the product.

The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settled in the air than in the water. Moreover, the density and viscosity of the air vary with temperature and pressure.

In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine product is usually taken away by the airflow. In some cases, the raw material is sent to a pulverized device from the airflow.

As is well known, the load of solid particles in the air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical direction is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverized coal and Western / cubic centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, each specificThe appropriate airflow rate in the case should be determined by experiments.

In the rising airflow, the water flow rate required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.

The Hammer Mill of Positive Electrode Recovery Plate has the characteristics of high pulverization, high pulverization efficiency, high pulverization accuracy, accurate cutting particle size, and good stability.

ALPA Chondroitin Hammer Mill of Positive Electrode Recovery Plate Case Sharing: The company is a professional manufacturer of active biological extracts, which requires a superfine pulverizer that meets GMP requirements, and investigates a number of powder equipment manufacturers. Finally, we purchased our AlPa's Hammer Mill of Positive Electrode Recovery.

finished particle size: 100 full pass
Production capacity: 120kg


Shandong Alpa Powder Technology Co., Ltd. specializes in Hammer Mill of Positive Electrode Recovery Plate product technology Production and development and service, welcome to consult. With perfect quality, excellent service, the most affordable price, customer first provides customers with the best eddy current crusher products and services.