Rod Pin Crusher for Nepheline

In this economically flourished area, there are many people who know the airflow crusher, Rod Pin Crusher for NepheLine technology is in a leading position in the same industry.

High-speed jet enters the crushing chamber, collides with particles, multiple times in the friction of high pressure air, shear and pulverized, pulverized materials, and the assembly of rising airflow motion, under the action of the fan, At the power of the ROD PIN CRUSHER For Nepheline, the thickness of the material is separated from the separation, the fine particle size of the pulverized wheel into the cyclone separator and dust removal, continues to be pulverized.

The pulverizer produced by AlPa can perform local internal changes depending on the different characteristics of the material, so that it is more suitable for the pulverization requirements of the material. The crusher has a greater amount of treatment, energy saving, simple operation, and low maintenance costs.

ALPA Composite Pin Rod Pin Crusher For Nepheline Case Sharing: This customer is a renewable resource company, which requires a different granular selection of composite powder to select a super fine powder less than 30 μm. Investigate a number of domestic grading equipment manufacturers, did not find the right equipment, and finally found the right equipment in our AlPa, and selected our vertical grading machine equipment. Product particle size: D97 ≤ 30μm hour yield: 80T
Welcome major composite powder manufacturers to visit, incompetent experiments.

ROD PIN CRUSHER For Nepheline Job Safety Application Basic Requirements
1, when the crushing machine works, the operator should stand in the tangent direction of the hammer rotation, and if you don't wear your gloves, your hand must exceed the safety line. It is not allowed to use iron and sticks instead of hand feed.
2, pulverizer and power unit should be installed firmly. If the equipment is fixed for a long time, it should be fixed on the cement; if the device is a mobile operation, the unit should be installed on the base made of angle iron, and ensure that the belt wheel groove of the power machine (diesel or electric motor) and the equipment is in the same Rotary plane.
At the same time, check if the leather belt looseness is appropriate.
4 Whether the power machine and the pulverizing machine are lubricated.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, you should pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking, do not have a long time overload.If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.

Users who want to view crusher related information can also log in to our website directly!