Impact Mill Machine Of Sweet Potato Flour

Everyone knows that choosing a product or service, to understand from all aspects of the milling machine, service, quality, etc.

Under the action of the high-speed rotary impeller, the gas pressure flowing through the impeller increases, and the high pressure airflow flows out of the impeller, the fine particles are ejected. Since the blade of the rotary vane is designed as a bending, the inlet is large, the exit cross-sectional area is small, so the airflow pressure at the outlet is reduced, the speed increases, and the rotational flow is conducive to classification.
The grading point adjustment mechanism sets three adjustment rods and keeps its synchronous motion using the chain. When the adjustment rod moves up, the fine powder increases; when the adjustment rod moves down, the fine powder is reduced. The graded point can be continuously adjusted, and the granularity of the IMPACT MILL MACHINE OF SWEET Potato Flour can be adjusted. The granular weight of the grading weight can reach D97 ≤ 3 ≤ 150 microns, which is suitable for fine grading of dry micrometer products.
The setting of the control ring is to ensure that the control ring is formed between the control ring and the radial particles ring, and the stability of the airflow flow is controlled. The residual windlet inevitably introduces excess gas from the dry material, the temperature of the classification chamber is high, and the air can expand, and therefore designed a residual tightening to maintain the stability and balance of the graded indoor airflow.


Alpa Pectin Impact Mill Machine of Sweet Potato Flour Case Sharing: Yantai A pectin shares, the company needs to purchase a superfine pulverized equipment for pulverizing gelatin. Through multi-party investment and incoming experiment, the company purchased our AlPa's Impact Mill Machine of Sweet Potato Flour as its pectin ultrafine pulverized equipment.
Technical parameters:
finished particle size: 60-200 mesh

Impact Mill Machine of Sweet Potato Flour Job Safety Application Basic Requirements
1, Crush When the machine operation, the operator should stand in the tangent direction of the hammer rotation, and if you don't wear your gloves, your hand must exceed the security line, not allowing iron and sticks instead of hand feed.
2, pulverizer and power unit should be installed firmly. If the equipment is fixed for a long time, it should be fixed on the cement; if the device is a mobile operation, the unit should be installed on the base made of angle iron, and ensure that the belt wheel groove of the power machine (diesel or electric motor) and the equipment is in the same Rotary plane.

4 Whether the power machine and the pulverizing machine are lubricated.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking bullies, do not have a long time overload. If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.

Shan dong alpa is a world-renowned particle and powder processing system provider. If you want to consult, you can ask Shandong AlPa to get the answer you want, but it is not just The price of a device, there may be powder technology solutions in your industry, welcome to call us.