Rotor Mill of CEMENT ADDIVE

In this economically flourished area, there are many people who know the airflow pulverizer, and Rotor Mill of CEMENT ADDITIVE technology is in a leading position in the same industry.

Rotor Mill of CEMENT Additive is suitable for combating machinery of materials such as synthetic resins, food, chemicals. The apparatus is different from the ordinary inner grinding machine, not only simply crushed, such as impact force and cutting force, but also by many generated ultrasonic eddy currents and vibration thus generated high-frequency pressure vibration to crush the material. Under certain conditions, the viscous material and the elastic material can also be pulverized.
The pulverizer is almost no increase in the temperature during the pulverization process, so the thermal material can also be pulverized. The pulverizer has a reasonable structure, stable operation, low energy consumption, large crushing capacity, small size, no fault, easy to clean and maintenance. General shells use water cooling and their own air volume, conveying crushing materials, improves temperature, and reduces thermal materials.

The wear of the blade is caused by the vibration of a large number of ultrasonic eddy currents and high frequency pressures generated by the blade. Compact, no dust, no dust.
ALPA Soybean Rotor Mill of Cement Additive Case Sharing: This customer is a company in the Netherlands. The company needs ultrafine pulverization to soybean meal (after oily oil). Investigating European equipment manufacturers, integrating, or our ALPA equipment is better than the performance ratio, or from cost performance. Through the incoming experiment, the company chose our company's Rotor Mill of CEMENT Additive.

1. Preparation before departure. Check if the host, connector, pipeline, and the valve are normal, working properly.

(1) Open the compressor power supply, the dust collector pressure valve and the main air valve, open the air pulverizer power switch, and turn on the power switch.

(2) From zero, gradually adjust to the specified speed.

(3) Open the fan, cyclone separator, dust collector, charge motor, open the total power box, set the inverter frequency, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.
3, the sequence of stops:

inverter-feeder-main air valve-compressor-grade impeller-motor cyclone material, dust removal switch-fan-main power supply-air compressor .
4, Maintenance

(1) ElectricityThe machine should be lubricated regularly, but the lubricant should not excessively avoid the bearing temperature.
(2) Check the wear of impeller, helical conveyors, and crushing nozzles.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag, it should be cleaned or replaced.
5. Precautions

(1) When the discharge equipment is run, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric chance are damaged.
(3) Regularly check the safety valve to ensure safety.
Welcome everyone to inquire!