Ring Roller Mills for Aerogel

With the continuous advancement of pulverizer technology, Ring Roller Mills for Aerogel has been familiar with people. Now the most popular crushing equipment is Ring Roller Mills for Aeriel. It has a wide variety, available for laboratory, home and factory use. It has a wide range of production, high energy consumption, high automation, and high classification quality.

Ring Roller Mills for aerogel has a wide range of smudged granularity, simple and convenient operation, but during the pulverization process, there is often a case where the crushing effect is different.

The crushing effect is mainly affected by the following factors:

The temperature and pressure of the gas ratio, the feed particle size, the working fluid, and the pulverization aid. The gas-solid ratio of the pulverizer in crush is an important technical parameter and an important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. But if the gas is too high, not only will waste energy, but will even degrade the dispersion performance of certain pigments.

When pulverizing hard materials, there is a stricter requirement for the particle size of the feed. In terms of titanium powder, it is necessary to control 100 to 200 mesh when pulverizing calcination; the material after pulverizing surface is generally 40 to 70 mesh, and cannot exceed 2 to 5 mesh.
So, should you choose how high pressure when crushing? Those skilled, this is mainly dependent on the comminutability and fineness requirements of the material.
ALPA FENI50RING ROLLER MILLS for Aerogel Case Sharing:

Case parameters:
Over Yield: 300kg

The temperature rise of the bearing must be checked frequently during the production process, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to exclude Fault. When the new machine is running, the drive belt is easy to elongate, pay attention to adjust the proper looseness of the belt to ensure the work life of the belt. If the lifting piece should be checked frequently, replace the production quality and production in time. The blade, the bushing should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is roughly discovered to be replaced. The host and the grading flow bearing are grease lubrication, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the amount of the grease is filled is shaft.1/2 of the inner space of the cavity can not fill the grease too much, which will cause too high of the bearing temperature.The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease.In the output shaft E, ie the pulley E, avoiding the weight of the weight, damage the part.It is strictly forbidden to turn the handle on the stop.The lubricating oil used in this regulator is used with N32 alkaline high-zinc high-grade anti-motor oil pressure oil, and the deceleration machine is 401 generally lubricating oil, and it is not necessary to use other machines.After four or five months, new oil should be replaced.