Turbo Mills for shell

Turbo Mills for shell is a very convenient device that can be used to crush all kinds of products, especially some fine particle products need to be used.

Airflow classification is from centrifugation, gravity, Based on the inertial force, different motion trajectories are produced according to the centrifugal force, gravity and inertial force of different particle sizes in the gas (usually air), thereby achieving classification of different particle sizes. The Turbo Mills for Shell can be divided into static classifiers and dynamic classifiers according to whether there is moving parts. The development of Turbo Mills for shell is getting better and better. Many industries need to control the particle size of fine powder.

AlPa Crystalline Sulfur Turbo Mills for Shell Case Sharing: Shenyang needs an apparatus capable of ultrafine pulverization of crystalline sulfur. Crystalline sulfur is a flammable and explosive raw material, so there is a very high demand of the explosion-proof system of the pulverized apparatus. After many examinations, our company's nitrogen protection Turbo Mills for shell met the production needs of the company. Turbo Mills for shell has an advantage in security, production capacity, energy consumption.
Technical parameters:
Finished particle size: 200-300 mesh
Production capacity: 1.5T

Let's talk about how to use Turbo Mills for shell
[ 123] First, prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it works fine.
Second, open

1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several turning wind turbines, cyclone separators discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can be adjusted by grading wheel frequencies and charging.
Third, the order of shutdown is: inverter - feeder - Main valve - Compressor - Stepper wheel Motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor.
4, repair

1. The motor should be lubed regularly, but the grease should not be too large, the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.

4. After the filter bag is a period of time, it should be cleaned or replaced.
V. Note

1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.
Shandong AlPa focuses on the production, research and development, sales of powder engineering equipment and other powder engineering equipment and other powder engineering equipment, the production of small ultra-fine pulverizer is three parts: mainframe, auxiliary machine, electric controlIt consists, the gas flow is pulverized, the airflow classification, the mechanical powder is integrated, flexible to realize the gas flow, airflow grading, mechanical powder is integrated, 325 mesh-10000 mesh (45μm), suitable for a variety of crushing scenes, from research institutes,College laboratories, new products and tests in the factory research institute.It is necessary to make the device selection according to the actual needs.Welcome new and old customers to come to consult!