Turbo Grinder of Catalyst Precursor

In the rapid development of rapid development, many people have a certain understanding of Turbo Grinder of Catalyst Precursor, and crusher technology is in an absolute leading position in the industry.

The overall development trend of China's material ultrafine crushing technology is to make a more ultra-fine pulverized equipment to various types of ultra-fine pulverization equipment towards low-cost, high efficiency, strong dispersibility, good dispersibility and stable quality. High technical requirements.
Turbo Grinder of Catalyst Precursor Engineering Technology will need more and more high-purity ultrafine powder, and ultrafine powder technology will play an increasingly important role in high-tech research and development. Although high-purity ultrafine powder is prepared by chemical synthesis, it is too high, which is extremely difficult for industrial production. The main means of obtaining the ultrafine powder is still mechanical and pulverized, and ultra-fine pulverization technology is a combination of many technologies. Its development also depends on the progress of the relevant technology.

Therefore, the main development trend of ultrafine pulverization equipment has been developed with fine pulverized equipment with ultrafine pulverized equipment. Ultrafine pulverized equipment with low energy consumption, small land, and has high handling capacity. Integrated development of equipment and process research.

Ultra-fine pulverization and supporting equipment must be adapted to specific bored features and product indicators, and the scale model must be adapted.

Technical parameters:
Finished granularity: D90: 15-30μm

1, during production, the temperature rise of the bearing must be checked, when warm When it is more than 50 ° C, it should be stopped, and the reason is to rule out the fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3, if the loss case should be checked frequently, replace the quality and production volume in time.
4, the blade, the bushing should often check the wear situation. If the wear is worn, the productivity is lowered, and the particle size is replaced after the particle size is replaced.
5, the host and the graded flow bearing are lipids, and the No. 2 special lipids are used 265-295.
6, the replacement period of the bearing is 2000 hours, and the filling of the grease is 1/2 (episode) of the space in the bearing cavity or3/4 (down test) Do not fill the grease too much or if it will cause too high of the bearing temperature.
7. The spiral feeder has been changed during the change of the lipid of 4,000 hours, and the calcium-based grease is added.