Rotor Mill for Amorphous Carbon

Rotor Mill for Amorphous Carbon uses a clean, efficient, high-level, high-yield of advanced crusher model in the pulverization of Western medicine raw materials, and tests from a few tens of grams of trace test. At the time of hundreds of tons of large production, gas flow milling with narrow particle size distribution, average particle size; good powder shape, high product purity; suitable for low melting point, thermistory drug; good sealable, low pollution; Easy to operate; crushing-mixed-dry online operations, etc. have been widely recognized by the company.

Rotor Mill for Amorphous Carbon works in work, and when the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.

Technical parameters:
Finished particle size: 200 mesh 90% pass
Production capacity: 4-5T

1, When the crusher is working, the operator should stand in the tangent direction of the hammer rotation, and if you don't wear your gloves, your hands must exceed the safety line, not allowed to use iron and sticks instead of hand feed.
2, pulverizer and power unit should be installed firmly. If the equipment is fixed for a long time, it should be fixed on the cement; if the device is a mobile operation, the unit should be installed on the base made of angle iron, and ensure that the belt wheel groove of the power machine (diesel or electric motor) and the equipment is in the same Rotary plane.
At the same time, check if the leather belt looseness is appropriate.
4Whether the power machine and the pulverizing machine are lubricated with the direction of the machine arrow.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking bullies, do not have a long time overload. If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.

Shan dong alpa is a world-renowned particle and powder processing system provider. If you want to consult, you can ask Shandong AlPa to get the answer you want, but it is not just The price of a device, there may be powder technology solutions in your industry, welcome to call us.