Impact Mill Machine for Quizalofop-P-Ethyl

With the continuous increase in social needs, Impact Mill Machine for Quizalofop-P-Ethyl is constantly improving in terms of performance, finished product quality, service life, etc., very good to process raw materials into micro-powder, and It has also been widely used in many fields such as chemical, food, pesticides, cosmetics, dyes, coatings, and electrons.

Impact Mill Machine for Quizalofop-P-Ethyl is mainly used for more refined materials. The pulverized particle diameter is 1.5 to 0.005 mm, and the crude material is sieved.
The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settle more in the air than in the water. Moreover, the density and viscosity of the air varies with temperature and pressure.
In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine particles are typically taken away by the airflow. In some cases, the raw material is sent to the gas stream into a pulverized device.

It is well known that the load of solid particles in air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration of the solid in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical directions is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverization coal per centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the airflow speed required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.

The Impact Mill Machine for Quizalofop-P-Ethyl has a wide comminuted range, high pulverization efficiency, high pulverization accuracy, accurate cutting particle size, and good stability.
Alpa Quartz Sand Impact Mill Machine for QuiZALOFOP-P-Ethyl case sharing: The customer needs to grades Quartz sand, compared to a number of powder equipment manufacturers, and finally pass the experiment, finally choose our AlPA classifier equipment. Product particle size: D95: 45μm hour Yield: 8-12T Welcomes major quartz sand manufacturers to visit, incompetent experiments.

1. If you clean the classifier, you need to pay attention The motor should not be stained with water, and the shaft is also the same.

3, usually pay attention to lubrication and maintenance of the bearing of the classifier.
4. If the precision classifier works for 1,500 hours, remember to add lubricant.

If you still have questions, you can directly contact the ALPA Technology Co., Ltd., warmly welcome users to come to consult, our company equipment is manufactured, the size is complete, there is a suitable for you!