Rod Pin Crusher of Montmorillonite

We all know that Rod Pin Crusher's Montmorillonite is a very strong airflow, many stubborn hard materials that encounter the crusher will be cut into a uniform block of pieces,

Rod Pin Crusher of Montmorillonite is a set of grading systems for airflow classification equipment, classifier, and cyclone separators, dust collectors, and airplanes. It can be accurately classified from 200-5000 destination materials, and the material is moved by the casing of the stratigraphic airflow at the lower airflow at the bottom of the flushing airflow to separate the crude material. Separate, The fine particles that meet the particle size requirements are collected by the grading wheel blade gap. The crude particles are partially fine particles to hit the wall, and the roll wall drops to the secondary tight air, the strong Amoy of the second wind The washing is separated, and the fine particles rises to the secondary grade of the fractionation region, and the crude particles are dropped to the unloading port. This can be accurately graded out of the 1000 purpose powder required by this customer.

AlPa Quartz Powder Rod Pin Crusher of Montmorillonite Case Sharing:
Silicon Microfubin Company's main products include molten stone sand, molten silicon powder, soft composite silicon fine powder, high purity ultrafine silicon powder, active silicon fine powder, Crystalline silicon fine powder, spherical silicon fine powder and other specifications are complete.
Main uses: Photovoltaic solar industry and electronic package materials, high temperature refractory materials, aerospace materials, quartz glass tubes, quartz ceramic rolls, and coated copper industries.
Case parameters:
Product particle size: Remove 20μm with fine powder
hour yield: Sylectivity 60-90%

Ultra-micro ROD PIN Crusher of MontMorillonite's correct usage: 1, the ultrafine pulverizer and power unit should be securely installed. If the ultrafine pulverizer is fixed, it should be fixed on the cement; if the pulverizer is a mobile operation, the unit should be installed on the base made of angle iron, and ensure the power machine (diesel or electric motor) and the pulverizer The belt wheel groove is in the same turning plane.
2, after the pulverizer is installed, check the fastening of the fasteners of each part, if there is loose to tighten. At the same time, check if the leather belt looseness is appropriate.
3 Whether the power machine and the pulverizing machine are lubricated.
4, do not casually replace the pulley to prevent the transition chamber to produce explosion, or the speed is too low to affect the work efficiency of the pulverizer.
5, the crusher should be first startedTurn 2 ~ 3min, no abnormal phenomenon, then press it.
6. At any time, you should pay attention to the operation of the pulverizer, and the feed should be evenly charged to prevent blocking, do not have a long time overload.If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.