Rod Pin Mill for Valsartan

Rod pin mill for Valsartan This product technology has been widely valued by the industry. ROD pin mill for Valsartan is mainly used to determine its wide range of applications, high fine, typical materials: super hard diamond, silicon carbide, metal powder, high purity requirements: ceramic pigment, medicine, biochemistry, medicine. Rod Pin Mill for Valsartan converts the normal gas from the gas source portion to nitrogen, carbon dioxide and other inert gas, is an inert gas protection device for use in flammable and explosive, oxidized materials.

The following is a detailed description:

1. Feeding granularity control

Most ROD PIN MILL for Valsartan has a certain upper limit requirement for the feed particle size. After entering the pulverization cavity, it can be sufficiently accelerated before collision and crushing with other particles. It is difficult to completely accelerate after large particles enter the pulverized cavity, which will allow them to stay in the machine too long, resulting in too high energy consumption. Therefore, in large-scale production of ultrafine powder, it is an effective way to pre-ground the raw material of the particle size is an effective pathway for energy saving.
2. Working medium

Currently, the working medium of ROD PIN MILL for Valsartan is mainly compressed, superheated steam, inert gas, and the like. The choice of working fluid has a certain impact on crushing effects and economics. Superheated steam is superior to air in fluidity and critical flow rates to achieve higher flow rates and uniform flow fields. However, using superheated steam as a working fluid, it must be ensured that it is still in an overheating state before entering the product capture device, otherwise the material is condensed.
3. Feeding speed

Feeding speed is an important parameter reflecting gas flow grinding production capacity. During the pulverization process, the optimum ratio of the intake flow rate and the feed speed is the key to improving the crushing efficiency. In general, under certain intake flow conditions, the feed speed is proportional to the particle size of the product. However, the feeding speed is too fast, which will increase the particle density, mutual interference, disadvantage of the particles, and difficult to achieve the sufficient and effective collision between particles, affect the crushing effect; although the feed speed is too slow, the particles stay in the crush area The time can be extended, which will reduce the particle density, reduce the collision rate, resulting in a decrease in production capacity and an increase in unit production energy consumption.
4. Granular limit

Rod Pin Mill for Valsartan during pulverization, as the material particle size is reduced, the material crystallizationUniformity and intensity increase. After reaching a certain degree, the particle size of the material is no longer reduced or reduced, that is, the crushing limit of the material is reached. At this time, the material specific surface area increases, the surface activity of the particles, the particle agglomeration and grinding are in a dynamic equilibrium state, even if the grinding time is prolonged, it is difficult to further reduce the particle size of the material.



ALPA Sodium Rod Pin Mill for Valsartan Case Sharing: This customer is mainly engaged in high energy chemistry, hydrogen production and hydrogen energy development, special gases, fine chemicals, environmental engineering, etc. Professional research design. The research institute requires a device that can be superfined with sodium chlorate. Find a domestic powder equipment enterprise. Finally, I bought a Rod Pin Mill for Valsartan in our Alpa.
Technical parameters:
Finished granularity: 100-325 mesh

How to maintain ultrafine rod pin mill for Valsartan, introduce the following points to everyone:
1, the pulverizer runs around each week, it is necessary to stop, check if the filter dust is blocked, clean the filter dusting film.
2, the bearing is marked, and the high temperature butter is added regularly, and the bearing is lubricated and maintained.

4, before each shift is parked, the air machine is loaded, and all the materials of the cavity are all discharged.

The Shan Dong Alpa is a scientific and technological private enterprise that produces a variety of airflow pulverities, integrating development, manufacturing, and application. The main product model has airflow pulverizer, airflow mill, pharmaceutical gas flow pulverizer, disc air pulverizer, eddy current pulverizer.