Turbo Mills for Ceramics

Modern production not only pursues production and finished product quality, but also develops toward environmental protection. In particular, in the comminution industry, the overall development trend of Turbo Mills for Ceramics technology in China is the stable development of the Turbo Mills for Ceramics technology.

Turbo Mills for Ceramics works mainly, after the material is accelerated through the nozzle, the compressed air enters the flow of the pulverized region, and the material is fluid, each particle has the same motion state. In the pulverized region, the accelerated particles collide with each other in each nozzle. The pulverized material is delivered to the grading area through the upper gas stream, and the fine powder of the particle size is selected by the horizontally arranged grading wheel, and the coarse powder that does not reach the granularity requirement, returns to the pulverization region to continue pulverization. Put the qualified fine powder with the airflow into the high-efficiency swirl separator, and purify the dust gas by the dust collector, discharged into the atmosphere, and the entire pulverization process reaches the high requirements of environmental protection.

ALPA Precipitated Sulfate Turbo Mills for Ceramics Case Sharing: Shenzhen Chemical Raw Material Company requires multiple large production, low-grained precipitated sulfate crushing production line. Our AlPA is a large enterprise in the powder equipment industry, and our equipment is customized. Different companies are used to meet different needs of different companies. In response to the needs of the company, our company customizes the production of five Turbo Mills for Ceramics, large mechanical crusher production lines to meet the customer's production needs.
Technical parameters:
finished particle size: D50: 0.8-5μm
Production capacity: 4.5 +/- 10% / T

Turbo Mills for Ceramics is too large What about the problem? Let's take a look.
1. If a lubricating oil is added to the rotating section, if the bearing and the shaft are relieved, the bearing will be adjusted; if the bearing wear is impeded, the bearing will be replaced.
2. There is also noise during the pulverization. The cooling sleeve can be used to reduce the temperature, which can allocate water in the crushing chamber.
3. Install a muffler on the fireplace of the crushing room.
4. Resistance equipment, such as using damping boards.