Vibration Grinder for Conductive Agent

Vibration Grinder for Conductive Agent can be used for important or need to be grounded to granular product processing, the ALPA ultrafine pulverizer product is good, affordable, factory direct sales, also to promote after-sales service service, service attitude

No matter what method adopted, the following conditions must be met:

1). The particle size of the product is fine, distributed narrow, can meet the actual requirements of production or research;

2). Product purity is high, free of impurities, no pollution, no damage to the environment;

3). High production automation, low energy consumption, simple process, continuous, safe and reliable.

Technical parameters:
finished particle size: D90: 400 mesh
Production capacity: 400kg / h

1 , The ultrafine pulverizer and power unit should be installed firmly. If the ultrafine pulverizer is fixed, it should be fixed on the cement; if the pulverizer is a mobile operation, the unit should be installed on the base made of angle iron, and ensure the power machine (diesel or electric motor) and the pulverizer The belt wheel groove is in the same turning plane.
2, after the pulverizer is installed, check the fastening of the fasteners of each part, if there is loose to tighten. At the same time, check if the leather belt looseness is appropriate.
3 Whether the power machine and the pulverizing machine are lubricated.
4, do not casually replace the pulley to prevent the transition chamber to produce explosion, or the speed is too low to affect the working efficiency of the pulverizer.
5
6. At any time, you should pay attention to the operation of the pulverizer, and the feed should be evenly charged to prevent blocking, do not have a long time overload.If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.