Turbo Crusher for Garnet

Turbo Crusher For Garnet is well balanced, only needs to be produced in a smooth ground, and low noise, which can avoid dust leakage during the pulverization process, which is favored by the powder industry.

In terms of airflow milling, it is important to understand its operational rules, which is very important because only familiarize the procedure, can operate correctly.
First, the rules of the Turbo Crusher for Garnet are as follows: After the preparation before the boot is received, it is prepared after the production order is received. Complete the site to clean the grocery. Check whether the transportation pipes and auxiliary equipment, whether the pipelines are blocked, leak or poor sealing, whether the auxiliary equipment is intact, whether it works normally. Whether there is a phenomenon that the material is accumulated in the outer casing and the separator, if the accumulated material is required. Whether the bearing is lubricated, whether it is lubricated in an appropriate place. Check if all pipes, fastening bolts, washers, spindles, and instruments are intact, normal and flexible.
Second, Turbo Crusher for Garnet starts the motor, control the current and time at starting, so that the device can start. When the equipment is operating normally, the feed speed can be adjusted according to the properties of the material. Uniform continuous feed should not be large or small, thereby affecting the separation effect of the grinding machine, making the machine easily malfunction. During operation, if an abnormality occurs, stop checking immediately before the failure continues.
Third, the main procedures of Turbo Crusher for Garnet are as follows: After the material in the grinding machine housing is completely pulverized, the feed should be stopped and the motor should be closed. After the machine is idling for 3 minutes, press the stop button to stop the machine. When the machine is completely stopped, open the check door and check the wear of the vessel. Fill in the corresponding production record, update the device status flag, which is convenient for the next use.


ALPA Water Available Feni50Turbo Crusher For Garnet Case Sharing: This customer needs a device that can make ultrafine pulverized metal powder. Finally, we purchased our AlPA CSM710-V mechanical grinder.
Technical parameters:
Production capacity: 200-250kg

Any mechanical equipment, there is a certain precaution before use, must check the precautions for operation, The damage rate is minimized, so what preventive measures are taken before use?
1. Check whether the firmware is tight before use, whether the spindle direction is correct, so as not to damage the machine.
2, lubrication should be carried out in accordance with the requirements to make the machine operating properly.

4, foreign matter should not be treated in time to avoid damage to the tool.
5. When using the crusher, if there is abnormality, it should be handled immediately to avoid a large loss.6. If damage should be replaced immediately, certain components should be checked.

The company provides free experiments and testing, and provides 24-hour consultation services, welcome to use.