Rotor Mills of Sulphur

Rotor Mills of Sulphur can be used for important or need to be grounded to granular product processing, AlPA ultra-fine pulverizer products are good, affordable, factory direct sales, also push after-sales service service for customers, service attitude

Typical materials are: super hard diamond, silicon carbide, metal powder, etc. High purity requirements: ceramic color, medicine, biochemistry, etc., low temperature requirements: medicine, PVC. By changing the normal air of the gas source into an inert gas such as nitrogen and carbon dioxide gas, it can be used as an inert gas protection device. Suitable for crushing of flammable and explosive and oxidative materials.

AlPa Chicken Protein Rotor Mills of Sulphur Case Sharing: The company is a company in Spain, which needs to smash a chicken protein, asking all kinds of powder equipment enterprises in Europe, and there is no suitable equipment. Later, I learned that our ALPA, the testism sent us a message, and we didn't know if it was received after receiving the email. But our ALPA still decided to try it, and then let the customer maidens will be experimentally. Through multiple experiments, we have identified a crushing equipment that meet the particle size needs of the company. Finally, the company also purchases the series of equipment.

Finished particle size: 100μm
Production capacity: 500kg


For long-term \"health\" of the equipment, we need to take some steps to protect it again.

Of course, in order to test the yield of a crusher, for some of the raw materials, for some screen holes, in order to determine the appropriate hammer sieve gap and suction, the useful life of the screen and the hammer can be obtained in a short time. Very high grinding efficiency data. However, in the production of feed grinding, such specific measurement data, according to the operator's work experience, the technical content of the crusher itself is two things. People with enrichment of experience and labor experience also require higher operating costs. When the hammer is worn, the gap between the hammer and the sieve increases, the friction is reduced, and the abrasive efficiency is lowered.
2. Rotor Mills of Sulphur mainly requires a reasonable use of reverse glitch: mainly to rush the side hair of the screen into the inside, greatly increase the friction, but this method is not used for a long time.After the globi polishing, the efficiency is lowered.It lasts for 30 minutes to 1 hour.
3. Put the friction piece into the Rotor Mills of Sulphur: The friction plate has the effect of the material ring, but the effect is limited.First, the teeth of the friction plate are in front of the hammer head, the friction surface is small, and the hammer is long-lasting; if the sieve area is too small, the output screen area will be reduced.
For any of the equipment, everyday maintenance can be performed, to ensure that the equipment can run for a long time, so daily is critical to the maintenance of Rotor Mills of Sulphur.


Shan Dong Alpa is committed to Rotor Mills of Sulphur, has a mature process process, has a high energy technology research and development team, specializing in crusher research and development, survive by quality, welcome everyone to come to consult.