Cell Crusher Of Aluminate

Cell Crusher Of Aluminate is a very common and common pulverizer. It has a wide range of applications involving many industries.

Cell Crusher Of Aluminate has a wide range of pulverized granularities, simple and convenient operation, but during the pulverization process, there is often a case where the crushing effect is different.

The crushing effect is mainly affected by the following factors:

The temperature and pressure of the gas ratio, the feed particle size, the working fluid, and the pulverization aid. The gas-solid ratio of the pulverizer in crush is an important technical parameter and an important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. But if the gas is too high, not only will waste energy, but will even degrade the dispersion performance of certain pigments.

When pulverizing hard materials, there is a stricter requirement for the particle size of the feed. In terms of titanium powder, it is necessary to control 100 to 200 mesh when pulverizing calcination; the material after pulverizing surface is generally 40 to 70 mesh, and cannot exceed 2 to 5 mesh.
So, should you choose how high pressure when crushing? Those skilled, this is mainly dependent on the comminutability and fineness requirements of the material.

A New Energy Technology is a professional lithium-ion power battery for new energy vehicles, lithium-ion batteries and lithium ions with energy storage High-tech enterprises in the R&D and industrialization of battery key materials, take the lead in achieving large-capacity manganese lithium-ion batteries in scale production and marketization application of power battery companies.
Case parameters:
Product particle size: D50: 3-25μm
Hour Yield: 3-10kg

First, prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it works fine.
Second, open

1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several turning wind turbines, cyclone separators discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can be adjusted by grading wheel frequencies and charging.
Third, the order of shutdown is: inverter-feeder-main valve-compressor-step impeller motor-cyclone discharge, dust removal switch - fan - totalPower - air compressor.
4, repair

1. The motor should be lubed regularly, but the grease should not be too large, the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.
4. After the filter bag, you should clean or replace it.
V. Note

1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.

Shandong AlPa is a source manufacturer specializing in Cell Crusher Of Aluminate. All the year round provides equipment for domestic and foreign customers. Welcome to inquire!