Rod Pin Mills for Oyster

With the continuous advancement of crusher technology, Rod pin mills for Oyster has been familiar with people. Now the most popular pulverized equipment is Rod pin mills for Oyster. It has a wide variety, available for laboratory, home and factory use. It has a wide range of production, high energy consumption, high automation, and high classification quality.

Rod Pin Mills for Oyster technology is designed and manufactured by the grading wheel.

There are usually two classification wheels: metal and ceramics, for some magnetic pollution-sensitive materials, the ceramic grading wheel must be used, and the current market is commonly used in the market. Another silicon nitride ceramic has excellent machining properties, high temperature resistance, corrosion resistance, wear resistance, high strength, high adhesion, low density, low friction coefficient and self-lubricity.

The grading wheel can be widely used in powder refining and grading industries. At present, the maximum diameter of φ180 mm is currently reached, the highest operating speed is 12,000 rpm, and the normal service life is more than 1 year. It has been successfully applied to Downstream users, the application is good. The maximum use of this classification wheel is to prevent metal pollution, in addition, its specific graviz is 40% lower than zirconia ceramics, which can not only greatly reduce the energy consumption of the motor, but can greatly lower motor energy consumption. Under existing motors, overcons can be achieved to obtain finer particles.

ALPA seaweed feed Rod Pin Mills for Oyster case Sharing: The company is a seafarer enterprise in Yantai. It is found to be smashing algae during breeding. After pulverizing it, it can be used as a feed for sea cucumber, saving feed purchases. cost. By comparing a long-term use of a Rod Pin Mills for Oyster, the cost of purchasing the feed can be purchased for a few years. The cost of this production line can save. The company purchased our AlPa Rod Pin Mills for Oyster.
Technical parameters:
Finished granularity: D90: 400 mesh
Production capacity: 400kg / h

How to continue ROD PIN MILLS for Oyster life? Here are the following aspects:
1, during the production process, the temperature rise of the bearing must be regularly checked. When the temperature rises to 50 ° C, inspection should be checked, find a reason, troubleshooting.
2, when the new machine runs, the transmission belt is easily stretched, and the tightness of the belt should be adjusted to ensure the life of the belt.
3, regular inspections for the lids, promptly guarantee the quality of production and production.
4, the blades and bushing should always check the wear situation. When wear,The productivity decreased, and the grains became thick.
5, host and gradient flow bearing oil grease lubrication, dedicated grease, and degree 265-295.
6, the cycle of the bearing is 2000 hours.The amount of the grease is filled into a 1/2 (upper test) or 3/4 (below the test), so we can't add too much grease.Otherwise, the bearing temperature is too high.
7. The spiral feeder is 4,000 hours, plus ordinary calcium based grease.