Multiple-stage Classifier in Series for talc

With the continuous increase in social needs, Multiple-Stage Classifier In Series for Talc is constantly perfecting in use performance, product quality, service life, etc., very good to process raw materials into micrometers or even nanoscale fine powder, and also It has been widely used in many fields such as chemical, food, pesticides, cosmetics, dyes, coatings, and electrons.

Multiple-Stage Classifier In Series For Talc components include drive motors, graded wheels, fine powder and coarse powder outlets, raw materials, and two air imports. In addition, it is widely used and is a very good machine. Vertical air grade machine can be used in square rock, heavy crystal stone, quartz, gypsum, silica, corundum, cement, alumina, etc. play an important role.

In the production process, we should pay attention to maintenance and maintenance of Multiple-Stage Classifier In Series for Talc. 1. In the production process, the bearing temperature should be checked regularly. When the temperature rises above 50 degrees Celsius, the machine should be stopped to find out the cause and troubleshoot. 2, when the new machine is running, the transmission belt is easily elongated. Pay attention to adjust the appropriate tightness of the belt to ensure the life of the belt. 3, should be checked regularly, replace it in time, and ensure quality and production. 4, should check the wear of the blade and lining periodically. If the productivity is lowered after the wear, the grain size is thicker and the wear is immediately replaced. 5, the host and the hierarchical flow bearing use grease lubrication. 6, the replacement period of the bearing is 2000 hours, the amount of grease is 1/2 or 3/4 (lower test) of the bearing cavity space cannot be filled with too much fat. Otherwise, the temperature of the bearing will be too high. 7, the spiral feeder changes the fat period of 4,000 hours, plus ordinary calcium based grease. 8, in the output shaft E, i.e., pulley E, avoid heavy hush, damage to the part. 9. It is strictly forbidden to turn the handle of the handwheel in the stop. 10. The lubricating oil used by the governor adopts N32 alkaline high-zinc high anti-milling oil, and the reducer uses 401 universal lubricants and cannot be replaced by other machines. 11. After use 3000 hours, the new oil should be replaced, then use after 500 hours of oil, then 1000Use it after hours.