Horizontal Air Classifier for Metallic silicon

In the rapid development of rapid development, many people have a certain understanding of Horizontal Air Classifier for Metallic Silicon, and crusher technology is in an absolute leading position in the industry.

Horizontal Air Classifier for Metallic Silicon features: high yield, low energy consumption, high grading efficiency. 2. Particle size: This unit is graded by an impeller. The stable grading process and special sealing measures effectively prevent the leakage of crude particles, so that the product has no large particles, the particle size is concentrated, and the grading accuracy is high. 3. The structure is reasonable, and 1-6 products can be produced at the same time according to user requirements. 4. Strong applicability: A closed or open joint operation can be combined with a variety of mill (air mill, mechanical mill, ball mill, Raymond mill, vibrating mill, etc.). 5. High degree of automation.

For Horizontal Air Classifier for Metallic Silicon blocking troubleshooting, Xiaobi talks about your opinion, I hope to have some reference roles. Crushes blockage is the most common fault of machinery. It may be one of the most common failures in mechanical design, but because improper operation can cause many faults. (1) The feeding speed is too fast, the load is increased, causing clogging. In the aquaculture process, pay attention to the deflection angle of the current table pointer at any time. If exceededSet the current, indicating that the motor overload and long-term overload will burn the motor. This situation should be reduced or closed immediately, but it can also be changed by increasing the feed speed to control the feed speed. Because the energy rolling mill is fast, the load is large, and the load fluctuates. Therefore, the current of the rolling mill is generally controlled around 85% of the rated current. (2) The incisor of the discharge tube is different or the interference is too fast, and the universal crusher is blocked, and the conveying equipment does not match, resulting in weakening or calm of the drainage pipe. In order to find a fault, we must first clarify the export transport equipment, not change, adjust the amount of feed, and the normal operation of the equipment. (3) The water content, aging, screening, crushing and sealing material of the hammer hammer are too high, and the general grinding will be blocked. There is a need to regularly update the working state of the hammer aging and the serious aging, and check the screen regularly. Improve the production efficiency of universal grinding machines, improve the reliability of non-clogging and grinding.