FL Multiple-stage Classifier in Series with Natural flake graphite

Fl Multiple-Stage Classifier In Series With Natural Flake Graphite is designed and developed using a mixed powder spraying principle. Suitable for pharmaceutical, food, chemical and other industries. It is widely used. Cold source forms a closed circuit circulation system, which takes advantage of energy and saving energy: warming can be reduced to zero down 196 degrees, depending on the embrittlement temperature of the material, the temperature can be controlled by the pulverization process, select the best grinding temperature, reduce the pulverization fine The degree can reach 10-700 energy consumption, and even reachabited micron wood fineness.

In the production process, the temperature rise of the bearing must be often checked, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to rule out the fault. When the new machine is running, the transmission belt is easy to elongate, pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt. If you want to check, you should replace production quality and production in time. Blades, the lining should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is replaced after the particle size is replaced. The host and the grading flow bearing are lipids, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the outer space space in the bearing cavity. Do not fill the grease. Otherwise It will cause too high of the bearing temperature. The spiral feeder has changed the lime than half a year, and the calcium-based grease is added. In the output shaft E, ie the pulley E, avoiding heavy hammer, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-z7-degree anti-motor oil pressure oil, and the deceleration machine is used 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.