Publish: 2021-09-09 08:35:13
Views:
Let's take a look at how to extend the use of FL / ITC Single Classify Wheel Classifier with plaster: 1, strictly follow the operating procedure; 2, easy to damage parts Pay attention to time check, replace it in time. 3. The device body has no rotating components, not affected by the lifetime of the bearing. However, due to the difference in powder hardness, the degree of wear is different, especially the wear of the hierarchy knife tip, our body part uses special material production, the use of the knife tip is at least more than one year, the knife tip is wear more than 1 cm or more It will affect the grading accuracy, in order to avoid affecting product quality, it is recommended to contact us to replace the knife tip; 4. It is recommended to use the long filter device to improve equipment stability, and ensure grading accurate.
FL / ITC Single Classify Wheel Classifier with PLASTER Switching When there is oil, it is necessary to change the FL / ITC Single Classify Wheel Classifier With Plaster. It has been exchanged into an industrial manufacturing field. Common production equipment is not only the advantage, sometimes FL / ITC Single Classify Wheel Classifier With Plaster will also be damaged. Let's take a look at how to check the repair equipment. Daily maintenance FL / ITC Single Classify Wheel Classifier with Plaster To check the power outlet, plug, the power cord has no oxygen offset, the break, if you don't have it, you can plug in the power test machine, when the motor is not rotated, When the round is rotatable, it can be concluded that one capacity fails in the two start capacitors of the machine. If you can send a discharge spark and a very fringe, the capacitor can be used; if the sparks and sound are weak, the capacity of the capacitance has dropped, and the new or add a small capacitor. If the airflow pulverizer does not use this method if the capacitor has been damaged, and it must be repaired with the same size. In addition to FL / ITC SingLe Classify Wheel Classifier with Plaster has a rod mill high-speed crusher, this crusher is a very good quality is very difficult, while daily maintenance is more important, the following is the maintenance of such airflow pulverizer . Check if the lubrication of the bearing is good to check if all fasteners are tight. Check if the drive belt is installed correctly and the situation is good. If the belt breakage should be replaced in time, when there is oil in the belt or the groove, apply a clean rag to clean. Check if the protective device is good, if it is found that the protective device is unsafe phenomenon, it should be excluded in time. Check that there is an ignorant or other debris in the damage chamber, if it is sometimes cleaned. Check if the hydraulic top machine head or the starting roof rod is returned, adjust whether the gasket is properly installed correctly and compact. The above is the knowledge of the product daily maintenance and maintenance of the FL / ITC Single Classify Wheel Classifier With Plaster.
E-mail: marketing@alpapowder.com
Add.: No.168, Wenhua Road, Advanced Manufacturing Industrial Park, Anqiu, Weifang City, Shandong Province, China.
Copyright © 2000-2019 | Shandong Alpa Powder Technology Co., Ltd. All rights reserved | Sitemap
