FL/ITC Vertical Air Classifier of potassium sulphate

Fl / ITC Vertical Air Classifier of Potassium Sulphate Working Principle: Passive fine powder is delivered to the hierarchy of the upper part of the comminution device through the rising airflow. The classifier classifies the qualified material and enters the cyclone collector (if a product having several particle size is required, add a plurality of vertical turbine grace machines). Fine tails are delivered to the bag dust collector via airflow. After filtration, the tail enters the exit of the lower part of the filter and empty the air. Main components of this unit: classifying machine, grinding, grading, synchronous completion, adjusting the speed of the classifier by frequency conversion speed, can adjust the product fineness. For example, if a machining process requires a number of granular sections of the product, then two to four can be increased on the basis of a standard classifier, so that the machine becomes a "two five" machines.

Let's talk about how to correctly use FL / ITC Vertical Air Classifier of Potassium Sulphate. Second, open
1. On the compressor power supply, the pressure valve and the main air valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. The zero start classification wheel is gradually adjusted to the specified speed.
3. Turn on the fan, the cyclone separator discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The granularity of the finished wheel can be adjusted by grading wheel frequencies and charging.

Third, the sequence of shutdown is: inverter - feeder - Main valve - Compressor - Steady wheel motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor. Fourth, repair
1. The motor should be lubricated regularly, but the grease should not be too large, the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the inner sticky of the chalk, so as to avoid blocking, thereby affecting the crushing effect.
4. After the filter bag is a period of time, it should be cleaned or replaced.
5. Precautions
1). When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2). Leaf rotation speed must not exceed the specified requirements, otherwiseThe temperature is too high, the impeller, and the electric machine are damaged.
3). Regularly check the safety valve to ensure safety.