FW/HTS Single Classifying Wheel ClassifierFishbone

FW / HTS Single Classifying Wheel ClassifierfishBone Principles: When the compressed gas passes the injection of the injector, the pulverized raw material enters the pulverizer, and there are a plurality of pulverized nozzles per circumscribed room. Spray supersonic airflow, so that the material is high-speed impact on the airflow and the material collides with each other, friction and pulverize, the grading tube separates the coarse particles, and the coarse particle circulation returns to the pulverizing chamber, and the interior closed circuit circulation is pulverized, and finally The mouth can be distributed uniform ultrafine powder. 1. Suitable for dry ultra-micro processes. Due to the large impact speed, it can be more than 2.5 mep, in general, it is easy to obtain 1-10 micron particles, depending on the properties of the material, it is possible to obtain less than 1 micron particles. 2. Because there is a closed circuit classification mechanism inside the pulverizer, the product is thick The particles constantly circulate, and thus the particles are uniform and the particle size distribution range is obtained. 3, the equipment has the advantages of short smashing time, simple structure, convenient operation, small area, low noise (72 decibel) and no vibration. 4, the efficiency is high when pulverization, can be pulverized, and the purity of the pulverized product can be maintained.

FW / HTS Single Classify Wheel Classifierfishbone's crushing effect is not overlooked, and the role playing in production is huge, so the feature of FW / HTS Single Classify Wheel Classifierfishbone is very important. 1. Analyze the type of equipment, design principles and other equipment, what is the structure, what effect is generated, only fully analyzes and understands these issues, in order to make the selected device fully satisfy its production requirements. 2. After the equipment is put into production, if it is easy to lose, it is required to replace the loss of loss. It is necessary to assist in the auxiliary equipment and operations, 3, reasonable control These will save time and money for future production. 4. To check the factory where you want to buy equipment, because the factory is very costly, and it is very complicated from design to manufacturing. Equipment manufacturers cannot fully introduce it. The equipment technical indicators given are also referenced by the device selection. You cannot fully represent the parameters of the device. 5, in the purchase powderWhen the offformer should be purchased as much as possible to complete the installation, save time, saving time and put into production. Since the equipment manufacturer is recommended is practical, if it is recommended to use bad equipment to customers, it is undoubtedly a brand. Although it has certain profit purposes, its use and equipment are reasonable, it is built in later periods. Maintenance is also very convenient, this is a good thing for crushing manufacturers.